DELL COMPUTER CORPORATION DIMENSION XPS PRO XXXN Processor Pentium Pro Processor Speed 150/180/200MHz Chip Set Intel Video Chip Set None Maximum Onboard Memory 128MB (EDO supported) Maximum Video Memory None Cache 256/512KB (located on Pentium Pro CPU) BIOS Unidentified Dimensions 305mm x 244mm I/O Options 32-bit PCI slots (4), floppy drive interface, IDE interfaces (2), parallel port, PS/2 mouse port, serial ports (2), ATX power connector NPU Options None [Image] CONNECTIONS Purpose Location Purpose Location ATX power connector ATX IDE interface 1 CN6 Parallel port CN1 Floppy drive CN7 interface Serial port 2 CN2 Front panel connector J10E1 Serial port 1 CN3 Front panel connector J10H1 PS/2 mouse port CN4 32-bit PCI slots PC1 – PC4 IDE interface 2 CN5 USER CONFIGURABLE SETTINGS Function Label Position » Factory configured - do not C1 Unidentified alter » Factory configured - do not J67D1 Pins 4 & 6 closed alter » CMOS memory normal operation J67D1 Pins 20 & 22 closed CMOS memory clear J67D1 Pins 18 & 20 closed » Password enabled J67D1 Pins 27 & 29 closed Password disabled J67D1 Pins 25 & 27 closed » Setup access enabled J67D1 Pins 28 & 30 closed Setup access disabled J67D1 Pins 26 & 28 closed DRAM CONFIGURATION (NON PARITY SIMMS) Size Bank 0 Bank 1 8MB (2) 1M x 32 None 16MB (2) 2M x 32 None 16MB (2) 1M x 32 (2) 1M x 32 24MB (2) 2M x 32 (2) 1M x 32 32MB (2) 4M x 32 None 32MB (2) 2M x 32 (2) 2M x 32 40MB (2) 4M x 32 (2) 1M x 32 48MB (2) 4M x 32 (2) 2M x 32 64MB (2) 8M x 32 None 64MB (2) 4M x 32 (2) 4M x 32 72MB (2) 8M x 32 (2) 1M x 32 80MB (2) 8M x 32 (2) 2M x 32 96MB (2) 8M x 32 (2) 4M x 32 128MB (2) 8M x 32 (2) 8M x 32 DRAM CONFIGURATION (PARITY SIMMS) Size Bank 0 Bank 1 32MB (2) 4M x 36 None 64MB (2) 8M x 36 None 64MB (2) 4M x 36 (2) 4M x 36 128MB (2) 8M x 36 (2) 8M x 36 CACHE CONFIGURATION Note: 256KB/512KB cache is located on the Pentium Pro CPU. CPU SPEED SELECTION CPU speed Clock speed Multiplier J6D1 150MHz 60MHz 2.5x 10 & 12, 11 & 13, 17 & 19 180MHz 60MHz 3x 9 & 11, 12 & 14, 17 & 19 200MHz 66MHz 3x 9 & 11, 12 & 14, 19 & 21 Note: Pins designated should be in the closed position.