TECHNOLAND, INC. OMNI 300-1, OMNI 300-4 Device Type Single board computer Processor 80386SX Processor Speed 25/33/40MHz Chip Set ALI Video Chip Set None Maximum Onboard Memory 20MB Maximum Video Memory None Cache None BIOS Award Dimensions 185mm x 122mm I/O Options Floppy drive interface, IDE interface, parallel port, serial ports (2), PC/104 connectors (2) NPU Options None [Image] CONNECTIONS Purpose Location Purpose Location Speaker J1 PC/104 connector J8A (8-bit) Reset switch J2 Auxiliary keyboard J9 connector Power LED & keylock J3 Serial port 2 J10 IDE interface J4 Serial port 1 J11 Floppy drive J6 IDE interface LED JP8 interface Parallel port J7 Power connector P1 PC/104 connector J8 (16-bit) USER CONFIGURABLE SETTINGS Function Label Position » CMOS memory normal operation JP3 Open CMOS memory clear JP3 Closed » WDT port address select port F2 JP4 Closed WDT port address select port F6 JP4 Open » On board I/O enabled JP5 Open On board I/O disabled JP5 Closed SIMM CONFIGURATION Size Bank 0 Bank 1 1MB (2) 256K x 16 None 3MB (2) 256K x 16 (1) 512K x 36 4MB (2) 1M x 16 None 5MB (2) 256K x 16 (1) 1M x 36 6MB (2) 1M x 16 (1) 512K x 36 8MB (2) 1M x 16 (1) 1M x 36 12MB (2) 1M x 16 (1) 2M x 36 20MB (2) 1M x 16 (1) 4M x 36 Note: Bank 0 is factory installed and is not configurable. ON BOARD MEMORY CONFIGURATION Size JP1 JP2 1MB Pins 1 & 2 closed Pins 1 & 2 closed 4MB Pins 2 & 3 closed Pins 2 & 3 closed Note: 1MB is standard on the Omni 300-1 board. 4MB is standard on the Omni 300-4 board. SERIAL PORT 2 SELECTION Setting JP9 JP10 JP11 JP12 JP13 RS-232 1 & 2 1 & 2 1 & 2 1 & 2 1 & 2 RS-422 2 & 3 2 & 3 2 & 3 2 & 3 3 & 4 RS-485 2 & 3 2 & 3 2 & 3 2 & 3 5 & 6 Note: Pins designated should be in the closed position. BIOS SELECTION Speed JP6 » 5v flash Pins 2 & 3, 4 & 5 closed 12v flash Pins 1 & 2, 4 & 5 closed EPROM Pins 2 & 3 closed M SYSTEM ADDRESS SELECTION Address JP7 C0000 Pins 1 & 2 closed C8000 Pins 3 & 4 closed » D0000 Pins 5 & 6 closed D8000 Pins 7 & 8 closed